PAYNTGUARD PROTECTIVE ZC GREY GREEN PRIMER is a single pack modified alkyd resin base rust inhibitive primer for priming on iron and steel. It is used on iron and steel surfaces under non-immersion conditions and it has an excellent adhesion and rust prevention to iron or steel substrates.
Typical uses: On iron and steel surfaces under non-immersion condition
Surface Preparation
Prior application of PROTECTIVE ZC GREY GREEN PRIMER: -
New surface: Surfaces generally must be clean, dry and free of all loose, dirt, dust, grease, wax, oil stain and other contaminants before paint application. Surface affected by rust must be power tool cleaned to minimum SSPC-SP2 or St 2 ISO 8501- 1:1988, free from mill scale. It must be dry and free from dirt, grease, oil stain and other contaminants before paint application.
Painted surface: For a strong preceding coat, light sanding is recommended. Meanwhile for a weak preceding coat, total removal of the coat is highly recommended. Then surface must be thoroughly cleaned, dried and free of all loose, dirt, dust, oil stain and other contaminants before paint application.
| Color | Grey Green |
| Film Finish | Matt |
| Drying Time | Touch dry 1-2 hours |
| Recoating Interval | ≥ 8 hours |
| Theoretical Coverage | Approximately 8 – 12 m² / liter (depends on surface conditions) |
| Coats | 1 or 2 Coats |
| Application | Brush, roller, air spray or airless spray |
| Thinner/Cleaner | Use Paynthinner 12 |
Safety, Health and Environment
During painting, make sure no source of ignition at surrounding and no smoking. Always remember to use protective equipment especially eye-goggles and a face mask to cover the mouth and nose. Remember to ensure adequate ventilation in rooms you are painting – open windows and doors wherever possible. In case of contact with eyes, rinse immediately with plenty of water and seek medical treatment. To remove splashes of paint from skin, use suitable cleanser or soap and water. When not in use, store paint in cool and shaded place and do not directly expose sunlight. Do not dispose paint into drains or watercourses. Wash your hands after use.
Refer to PAYNT Technical Data Sheet (TDS) for further details. - click button for pdf
Safety Data Sheet (SDS) is available upon request.
Photo gallery
PAYNTOXY finish is a two-pack polyamide cured epoxy finishing and intermediate coating. It has high content quality pigments produce a continuous paint film after dry and cures through wide temperature range...
Enquiry Now
Reach out to us via our contact form below and we will get back to you as soon as possible!