PACRYLIC PROTECTIVE PRIMER is an acrylic solvent-based sealer. It is formulated to protect the finishing coats against the effect of alkalinity and moisture from the wall. It has good penetration into painted substrates and thus protects the painted surfaces.
Typical uses: Retaining wall, interior or exterior building, tower, pavement brick, concrete cement and masonry surfaces.
Surface Preparation
Prior application of PACRYLIC PROTECTIVE PRIMER: -
New surface: Surfaces generally must be clean, dry and free of all loose, dirt, dust, grease, wax, oil stain and other contaminants before paint application.
Painted surface: For a strong preceding coat, light sanding is recommended. Meanwhile for a weak preceding coat, total removal of the coat is highly recommended. Then surface must be thoroughly cleaned, dried and free of all loose, dirt, dust, oil stain and other contaminants before paint application.
| Color | White |
| Film Finish | Matt |
| Drying Time | Touch dry 20 minutes |
| Recoating Interval | ≥ 2 hours |
| Theoretical Coverage | Approximately 8 – 11 m² / liter (depends on surface conditions) |
| Coats | 1 or 2 Coats |
| Application | Brush, roller, air spray or airless spray |
| Thinner/Cleaner | Use Paynthinner / Paynthinner 12 |
Safety, Health and Environment
During painting, make sure no source of ignition at surrounding and no smoking. Always remember to use protective equipment especially eye-goggles and a face mask to cover the mouth and nose. Remember to ensure adequate ventilation in rooms you are painting – open windows and doors wherever possible. In case of contact with eyes, rinse immediately with plenty of water and seek medical treatment. To remove splashes of paint from skin, use suitable cleanser or soap and water. When not in use, store paint in cool and shaded place and do not directly expose sunlight. Do not dispose paint into drains or watercourses. Wash your hands after use.
Refer to PAYNT Technical Data Sheet (TDS) for further details. - click button for pdf
Safety Data Sheet (SDS) is available upon request.
Photo gallery
PAYNTOXY finish is a two-pack polyamide cured epoxy finishing and intermediate coating. It has high content quality pigments produce a continuous paint film after dry and cures through wide temperature range...
Enquiry Now
Reach out to us via our contact form below and we will get back to you as soon as possible!